Description:

Orbit & SunPod Hanging Kit - Adjustable wire hanging system securely suspends Orbit or SunPod light fixture over your aquarium. Orbit & SunPod Hanging Kit is a sleek metal hanging system converts your aquarium-mounted Orbit or SunPod fixture into a ceiling-mounted fixture, allowing easy access to your aquarium. Helps minimize heat transference to aquarium water and improves air circulation to help maintain optimum performance of your Orbit or SunPod light fixture. Mounting and hanging hardware included.

- Sleek, metal design complements Orbit/SunPod high output light fixtures.
- Adjustable wire suspension system allows easy access to your aquarium.
- Converts your aquarium-mounted light fixture into a pendant fixture.

Installation Instructions
Removing Docking Mounts (If docking mounts are installed)

   1. Make sure the power for the light fixture is turned off. Slide the bottom cover approximately 2" out and slide docking mounts out of outer tracks. Slide bottom cover back into place.

Installing Mounting Brackets

NOTE: These brackets are designed to mount the Orbit or SunPod light fixture to the Hanging Kit. They are NOT designed for mounting the light fixtures into a canopy. Hanging installations must be used with a glass canopy or top.

   1. Make sure the power for the light fixture is turned off. Remove the two top screws from each side panel.
   2. Slide the bracket into place, top side (keyhole slots) facing up. Thread top screws back in place and attach bracket firmly into the side.

Hanging Instructions:

   1. Locate wood beam in the ceiling. Using mounting bracket as a template, drill two pilot holes in the intended locations. Do not install in drywall.
   2. Slide hanging screws into bracket top down. Place mounting bracket on ceiling and screw into wood beam using wood screws.
   3. Align hanging screws with mounting cap and slide screws through the cap. Thread hanging cap bolts on and tighten.
   4. Adjust hanging wire to desired height by pressing the wire outlet in and sliding cable in and out. Note: Ensure that the fixture is unplugged from the AC outlet. Slide cable connectors into the keyhole slots located on the mounting brackets and hang fixture.
   5. Adjust and level the height of the fixture using Step #4 above.

To avoid possible electric shock, special care should be taken since water is employed in the use of aquarium equipment.

    * If an electrical appliance falls into the water, or water drips onto the electronics, don't reach for it. First unplug it and then retrieve it. If electrical components of the appliance get wet, unplug the appliance immediately.
    * Always unplug appliance from main outlet when not in use, before putting on or taking off parts, and before cleaning. Never yank the cord to pull the plug from the outlet. Grasp the plug fully and pull out to disconnect.